Top of Page

STEP 1

Measure the distance from the bottom of the glass to the bottom of the hanging board.

STEP 2

Position the mirror onto the wall and make a chalk mark on the wall immediately below the bottom edge of the glass

STEP 3

Remove the mirror and using the measurement calculated in Step 1, make another mark directly above the one made in Step 2.

STEP 4

Holding the timber wall mount supplied so that the mitred edge is on the top and running along the chalk mark made in Step 3, mark the hole positions. Ensure that the timber wall mount is even by using the spirit level.

STEP 5

For Timber Walls Drill 3mm (1/8) holes into the wall. Using the screws supplied, fix the timber wall mount onto the wall as shown in diagram B.
For Masonary Walls Using a masonary drill bit, drill a 5mm (3/16) hole into the wall andtap the red wall plugs into the holes. Using the screws supplied, fix the timber wallmount onto the wall as shown in Diagram B.
For Gypsum, Gyprock & Plasterboard Walls Drill 5mm (3/16) holes into the wall. Screw the nylon wall mates into the holes with a screwdriver to finish flush. Using the screws supplied, fix the timber wall mount onto the wall as shown in Diagram B.
For Tiles Using a tile drill bit, drill a 5mm (3/16) hole into the wall and tap the red wall plugs into the holes. Using the screws supplied, fix the timber wall mount onto the wall as shown in
Diagram B.

STEP 6

Position the mirror into place and check that it is hanging correctly. If adjustment is necessary, remove the mirror and simply use packing material such as a match, paddle pop stick or folded cardboard placed onto the timber wall mount to adjust mirror.